国产成人精品高清久久_好姑娘影视在线观看高清_99久久久久久久久_欧美涩涩网_久久国产精品91_9色网站

FLDO3306ST_FLDO3307ST_FLDO3501S_FLDO3502S_FLDO3503C流量計OMEGA

流量計配備內置的6圈式針閥、具有"非上升型閥桿"的16圈高精度計量閥，或者可以不配備任何閥門。只要是要求高靈敏度控制和高分辨率的情況，特別是與測量極低流量的計量管配合使用時，成本較高的高分辨率閥門就物有所值。***般而言，在計量氣體時，建議將閥門安裝在入口處（底部）；在計量液體時，閥門既可以安裝在入口也可以安裝在出口處處（頂部）。對于真空應用，閥門必須安裝在出口處。如果在訂購時未指定，在發貨時閥門將安裝在流量計的入口處。

FLDO3306ST_FLDOFLDO3306ST_FLDO3307ST_FLDO3501S_FLDO3502S_FLDO3503C流量計

標準精度：滿量程的±5%

重復性：±0.25%

可用流量范圍：最小為10:1

最大工作壓力：200 psig/13.8 bars

最高工作溫度：121°C (250°F)

材質

流量管：厚壁硼硅酸鹽玻璃

浮子：玻璃、紅藍寶石、316不銹鋼、鎢鈷硬質合金和鉭與液體接觸的安裝接頭的選擇：黑色陽極氧化鋁或316不銹鋼

側面板：黑色陽極氧化鋁

正面防護罩：帶有縱向放大透鏡的聚碳酸酯樹脂，可增強讀數分辨率

背板：1?8”厚白色丙烯酸樹脂

O形圈和填料：鋁質／銅質流量計中采用丁鈉橡膠O形圈。不銹鋼流量計中采用氟橡膠O形圈

選配：全氟橡膠和EPR

連接口：1?8 NPT內螺紋入口和出口連接口

FLDO3306ST_FLDOFLDO3306ST_FLDO3307ST_FLDO3501S_FLDO3502S_FLDO3503C流量計

Flowmeters are equipped with built-in 6-ring needle valves, 16-ring high-precision metering valves with "non-ascending stem", or may not be equipped with any valves. As long as high sensitivity control and high resolution are required, especially when used in conjunction with metering tubes for measuring very low flow rate, high-cost high-resolution valves are worth the money. Generally speaking, when measuring gas, it is recommended to install the valve at the entrance (bottom); when measuring liquid, the valve can be installed at both the entrance and the exit (top). For vacuum applications, valves must be installed at the outlet. If not specified at the time of ordering, the valve will be installed at the inlet of the flowmeter at the time of shipment.